Carbide hole cutter 85 mm with adapter SDS+ and pilot drill bit

SB SR work boots, steel toecap, size 40, 82-161-40 by NEO TOOLS are boots belonging to the SB SR category. Equipped with a steel toecap, knitted mesh upper, knitted mesh lining, EVA rubber sole and HI-POLY foam insole characterised by exceptional durability. NEO TOOLS half-boots are resistant to slipping on ceramic ground covered with sodium lauryl sulphate solution (SLS) and on steel ground covered with glycerol. The insoles provide protection against impacts with an energy equivalent to 200J, as well as resistance to oil, petrol and other organic solvents. The knitted upper is woven from a single thread, which contributes to the footwear's lightweight construction and very good fit to the foot. The product is CE certified. It is offered in a wide range of sizes. The SB SR work boots by NEO TOOLS are proven footwear for work and everyday use.

Colour matching lamp 2 in 1 + station and charger 99-098 by NEO equipped with LED: COB and a UV diode. It has a colour rendering index CRI>90 and is characterised by the following functions: COB warm - COB natural - COB cool - TOP UV LED-OFF, where the maximum output powers are: 380 lumens (warm) / 350 lumens (natural) / 390 lumens (cool). The operating time, on the other hand, is estimated to be between 4 and 4.5 hours, depending on the selected mode. The lamp has a 3.7V 4000 mAh battery and a 5V 1A power supply. The built-in type C charging port allows the device to be fully charged in 5 hours. The lamp for colour matching car paintwork under natural and UV light will be a must-have for any bodyshop. It will also prove useful in the case of coolant leaks, if the correct doped refrigerant is used beforehand. The unit has an IP67 waterproof rating. Its size is 185 x 50 x 32 mm and its weight (without base) is 245 g. The lamp is offered with a station, charger, hook and base magnet. Recommended for professionals as well as DIY enthusiasts.

Sanding canvas in roll 2.5 m x 115 mm, P60, 58T441 by GRAPHITE is an accessory for sanding metal, wood, plastic and plasterboard. The product is made on the basis of J-type canvas, which is characterised by high flexibility and durability. The abrasive has a solid blank - 100% of the surface is covered with abrasive grain (electrocorundum), ensuring effective sanding. GRAPHITE brand canvas is designed for hand sanding.

GRAPHITE metal drill with 13.0 mm diameter is made of high quality alloy of high speed steel. 124° point angle and chisel edge correction allow for easy drilling without punching. Designed for fast and efficient drilling in steel workpieces.

Segmented diamond cutting disc, 125 x 22.2 mm, dry and wet 57T308 by GRAPHITE is a segmented dry and wet cutting disc with a diameter of 125 mm and a mounting hole of 22.2 mm. The cutting segment is 7 mm high and 2 mm wide. The maximum speed of the disc is 12,200 rpm, corresponding to 80 m/s. The GRAPHITE blade meets the requirements of the EN13236 standard. It is designed for cutting granite, concrete, brick, stone and marble.