Äskettäin katsotut tuotteet
52-2093244
- EasyTRONIC MICRO II electronic control with pressure sensor operation as standard, thus preventing motor overload, reducing wear and extending service life
- With star-delta switch
- High cooling effect and lower noise level due to thermostatically controlled radial fan
- Operating hours counter records load and overrun times, thus ensuring compliance with maintenance intervals - Indication of maintenance requirements via automatic message
- Rotation direction control for the motor avoids possible damage during commissioning or after a change of location
- Screw compressor with wear-resistant Poly V ribbed belt drive and slide clamping system
- Easy maintenance due to easily accessible elements
- Optimum operating temperatures due to thermostatically controlled fan, optimum cooling air flow and generously dimensioned heat exchanger, thus longer service life, lower fluctuations in oil temperature than with thermostat control
- Aftercooler as standard, thus less effort for drying and filtration of the generated compressed air
- Small external dimensions, thus easy transport and installation
ManufacturerAircraft Kompressorenbau und Maschinenhandel GmbH
Gewerbestraße Ost 6, 4921 Hohenzell, Austria
info@aircraft.at
52-2023085
- Two-stage compression 2-cylinder high-performance unit with cast iron cylinder block
- The low speed ensures quiet, low-vibration operation and a long service life
- Large fan wheel for optimal cooling
- High quality electric motor with high torque
- Electric motor equipped with motor protection switch
- With phase inverter for easy manual reversal of the direction of rotation
- Intermediate and aftercooler reduces the formation of condensation
- Maintenance block with two pressure gauges for tank pressure and working pressure and high quality CONDOR pressure switch
- Fifteen-year rust-through warranty on inside and outside hot-dip galvanized compressed air tank
- Fully automatic on-off operation
- Ready for connection with all fittings
Increased flexibility
- By connecting the second compressed air tank, the container volume is doubled, whereby a higher air supply can be established
- An increased demand for air can thus be covered in the short term.
- The second compressed air tank can be disconnected from the compressed air supply e.g. for chiselling or sandblasting. This halves the container volume and pressure builds up faster.
Equipment details:
- K version with refrigeration dryer with integrated automatic steam trap as standard
- Pressure dew point 5 °C, compressed air inlet temperature 35 °C, cooling air temperature 25 °C
- K version additionally with pre-filter for separating condensate and solid impurities with particles up to 1 μm
- Compressed air quality according to ISO 8573-1
- As a pre-filter in front of the refrigeration dryer
- KK version with automatic steam trap on the compressed air tank
- This condensate drainage without unnecessary pressure loss
- Condensate conditioner for oil-water separation
ManufacturerAircraft Kompressorenbau und Maschinenhandel GmbH
Gewerbestraße Ost 6, 4921 Hohenzell, Austria
info@aircraft.at
