METALLKRAFT

The combination tooth with a 0° rake angle in combination with the group set sawing also saws thin-walled profiles with particularly low vibration. Short chipping material is machined without any problems. The M42-SPRINT bi-metal saw blade increases the tool life and creates a good cutting quality.

The specialist for:

• Common steel grades up to approx. 1400 N/mm² tensile strength
• non-ferrous profiles
• single and bundle cuts
• Profiles with low or medium wall thickness
• sheet metal panels on vertical panel sawing lines

The combination tooth with a positive rake angle in combination with the group set chips solid material and thick-walled profiles with particularly low vibration, increases the cutting performance and produces a smooth surface.

The specialist for:

• common steel grades up to approx. 1400 N/mm² tensile strength NF profiles
• single and bundle cuts workpieces of medium or large dimensions
• thick-walled profiles

• requires article 3640313 - this must be ordered!

The reinforced HL-combi-tooth with a slightly positive rake angle in combination with a group setting cuts solid material and profiles with particularly low vibration, increases the cutting performance and offers smooth surfaces with a convincing tool life.

The specialist for:

• small and medium-sized swing frame machines
• common steel grades up to approx. 1400 N/mm² tensile strength
• single and bundle cuts
• profiles and beams
• solid material

• HSS core drill set Ø 12/14/16/18/20/22 mm
• with 19 mm Weldon shaft and 30 mm drilling depth

• Steel < 500 N
• Steel < 750 N
• Steel < 900 N
• Steel < 1100 N
• Steel < 1400 N
• Stainless steel < 900 N
• Stainless steel>900 N
• Alu < 10% Si
• Alu>10% Si
• Copper, brass, nickel, tin
• Plastics GFK / CFK
• cast iron
• Hardox, Hastelloy, Inconell, Nimonic, Exotic materials
• graphite

• rails

• manufactured in elaborate pre-middle trimmer geometry
• Thus: vibration-free, quiet and easy cutting with maximum service life

• Made with conical spiral
• Thus: clean chip flow and highest cutting performance, even with difficult materials (heavy-duty machinists)

• Only equipped with Sandvik carbide teeth
• NOTE: Only the best carbide is good enough for Karnasch core drills

• Steel < 500 N
• Steel < 750 N
• Steel < 900 N
• Steel < 1100 N
• Steel < 1400 N
• Stainless steel < 900 N
• Stainless steel>900 N
• Alu < 10% Si
• Alu>10% Si
• Copper, brass, nickel, tin
• Plastics GFK / CFK
• cast iron
• Hardox, Hastelloy, Inconell, Nimonic, Exotic materials
• graphite

• rails

• manufactured in elaborate pre-middle trimmer geometry
• Thus: vibration-free, quiet and easy cutting with maximum service life

• Made with conical spiral
• Thus: clean chip flow and highest cutting performance, even with difficult materials (heavy-duty machinists)

• Only equipped with Sandvik carbide teeth
• NOTE: Only the best carbide is good enough for Karnasch core drills